Mamiya Digital Camera 645 AFD User Manual

Mamiya 645 AFD Instruction Manual Companion for  
D ig it a l P h o t o g r a p h y  
 
Internal LCD  
External LCD  
Condition #1  
This display will appear before the shutter has been released (Normal  
mode). At this point the Mamiya 645AFD will act as if there is a film  
magazine attached and will display shutter speed and aperture respec-  
tively. This indication will not appear under conditions 4b, 5 and 6.  
Condition #2  
This will appear under normal shooting conditions after the shutter has  
been released (Capture mode). CaP db tells us the digital back is in the  
process of capturing an image. It will be displayed until the digital  
capture is complete except under conditions 4b, 5 and 6.  
Condition #3  
After the CaP db display these indicators may appear (After Capture  
mode). Db-E indicates a digital back exposure warning. The +1.3  
confirms the meter reading is +1.3 stops higher than the set exposure  
on the camera. It will appear in the Manual and X exposure modes. If  
the exposure setting set on the camera does not agree with the expo-  
sure determined by the meter, this will be displayed showing the  
difference between the two. When this appears, it will blink for three  
seconds. It can be cancelled by pressing any button.  
 
Condition #4  
Internal LCD  
External LCD  
After CaP db is displayed these indicators may appear (After Capture  
mode). It confirms the digital back is storing an image and that there  
are certain number of frames left in the memory of the digital back. This  
indicator shows the remaining frames left by displaying Stor 88 (where  
88 is a number between 99 and 1). This will be displayed when the  
frames-to-go is less that 100. This display will blink for 3 seconds and  
can be cancelled by pressing any button. Note: Some digital backs will  
only display Stor db in this instance. If the db-E and Stor conditions are  
both true, the db-E will be displayed for 3 seconds and then Stor will  
be displayed for 3 seconds.  
Condition #4b  
This indicator may appear before the shutter has been released (Normal  
mode). This is warning that the storage capacity of the digital back has  
been reached. If the shutter release button is pressed at this time the -  
no- db indication will blink for 3 seconds.  
Condition #5  
When the battery of the digital back has been exhausted this indication  
will appear. If the shutter release is pressed the -no- db indication (see  
condition #7) will be displayed and blink for 3 seconds.  
 
Condition #6  
Internal LCD  
External LCD  
When the digital back or host computer is busy, this indicator will be  
displayed. If the shutter release is pressed the -no- db indication (see  
condition 7) will be displayed and blink for 3 seconds.  
Condition #7  
If the digital back is connected to the Mamiya 645AFD and the connec-  
tion to the host computer is not installed, this will be displayed when  
the shutter release is pressed. This will also appear under the previous  
three conditions when the shutter release is pressed.  
 
M AM IYA AM ERICA CORPORATION  
8 Westchester Plaza, Elmsford, NY 10523  
Phone: (914) 347-3300 · Fax: (914) 347-3309  
E-mail: info@mamiya.com  
 

Learning Resources Games LER 3044 User Manual
Lincoln Electric Welder 11458 User Manual
Lindy Computer Accessories 70907 User Manual
Loewe Flat Panel Television Aventos 3772 Z User Manual
Magnavox VCR VRX344AT User Manual
Matrox Electronic Systems Computer Drive MKey 100 User Manual
Maxtor DVR ELX8 60 User Manual
Melissa Computer Monitor 653088 User Manual
Mellerware Iron 2 3 5 0 02000W User Manual
Midland Radio Camcorder XTC 200 User Manual