Memorex CD Player MX9790 User Manual

Mini Compo CD Player  
with Radio  
Model: MX9790  
Memcorp, Inc.  
Weston, FL  
Printed in Hong Kong  
Note: Please read and follow these instructions before using your unit.  
 
LOCATION OF CONTROLS  
CONNECTING THE LOUDSPEAKERS  
Connect the cables of the two loudspeakers to the corresponding input (R) for the  
right speaker and input (L) for the left speaker, located at the back of the unit.  
Warning:  
z
z
Connect the loudspeakers before powering the unit:  
The unit may not work properly or get damaged if you use speakers  
different than the ones supplied with the unit  
AC OPERATION  
Connect the plug to the AC socket of the unit and the other end to a standard AC  
outlet.  
ATTENTION  
1. Do not plug or unplug the power cable while you have wet hands;  
2. When planning not to use this unit for a long time, disconnect the power  
cable from the wall outlet;  
3. When disconnecting the power cord from the wall outlet, do not pull on the  
cord in order to avoid shock risks caused by damaged cable.  
1. Speakers  
2. Function Switch  
3. Power Switch  
4. Stereo Headphones Jack  
5. Volume Control Knob  
6. Skip / Backward Search Button  
7. Remote Sensor  
16. Minute Set Button  
17. Repeat Button  
18. Play/Pause Button  
19. FM Stereo Indicator  
20. Stop Button  
SET THE CORRECT TIME  
Before starting to set the time, make sure that the Function Switch is not on Radio  
position.  
Press and hold the time button as well as the Hour and Minute buttons simultaneously,  
in order to set the time. Release all buttons when reaching the correct time.  
21.  
CD Door  
22. Tuning Knob  
8. Skip / Forward Search Button  
9. Power Indicator  
10. Program Button  
11. ON / OFF Alarm Switch  
12. Display  
23. CD Door Open Button  
24. CD Door Close  
25. Band Switch  
26. AC Socket  
27. Left Speaker Jack  
RADIO OPERATION  
1. Set the Function Selector to Radio position;  
2. Set the band selector to AM/FM position;  
3. Adjust the TUNING control to tune in a radio station.  
(CD, Time, AM/FM Station, Alarm)  
13. Alarm Set Button  
14. Time Set Button  
28. Right Speaker Jack  
29. FM Wire Antenna  
SET THE ALARM TIME  
Before starting to set the alarm time, make sure that the Function Switch is not on  
Radio position.  
15. Hour Set Button  
Press and hold simultaneously the Alarm button as well as the Hour and Minute  
buttons, to adjust the alarm time. Release all buttons when reaching the desired alarm  
time and the display will go back to regular time.  
- 4 -  
- 3 -  
 
PROGRAMMING THE CD PLAYER  
RADIO WAKE UP FUNCTION  
The programming of the CD player should be done during STOP mode.  
1. Press the PROGRAM button to begin programming the CD player;  
2. Press SKIP or SKIPbuttons, to select desired track;  
3. Press PROGRAM button again to store this track in memory;  
4. Repeat steps from 2 to 3 to store more tracks in memory. You can store a  
maximum of 19 tracks in the memory.  
Select the desired radio station and set the volume to the desired level and  
make the following steps:  
1. Slide the Function Switch to auto position;  
2. Press the ALARM ON/OFF button once to activate the alarm  
function and the display will show "((((( • "indicating that the alarm is  
ON and press the ALARM ON/OFF button again to cancel;  
3. Set the alarm time as indicated at the SET ALARM TIME section  
and the unit’s radio will turn on at the pre-selected time.  
5. Press PLAY/PAUSE button to play the disc in the programmed order;  
6. To stop playing, press STOP;  
7. To cancel the programming, press STOP button and open the CD player  
door or select a different function (OFF/RADIO etc.)  
BUZZER WAKE UP FUNCTION  
Follow the same instructions as for Radio Wake up Function, but slide the  
Function Switch to Alarm position. The buzzer will sound for 3 minutes.  
REPEAT FUNCTION  
To repeat the same track:  
-
Press REPEAT button before or while playing the song. The REPEAT  
symbol " " will light up on the display.  
To repeat the whole disc:  
CD PLAYER OPERATION  
To play a CD, please follow the steps underneath:  
1. Set the Function Selector to the CD position;  
2. Press the OPEN button in order to open the CD door;  
3. Insert the CD with the printed side facing up and close the CD door;  
4. Disc information (total number of tracks) will appear on the LED  
display;  
-
Press REPEAT button twice. The REPEAT symbol "  
the display.  
To cancel the repeat function:  
" will light up on  
-
Press REPEAT button three times. The REPEAT indicator will be cleared  
from the display.  
5. Press PLAY/PAUSE button to start playing the CD;  
6. Adjust the volume control to the desired volume level;  
7. Press STOP, to stop playing the CD  
PAUSE FUNCTION  
1. While playing a CD, press PLAY/PAUSE button once to temporarily pause  
the play.  
2. Press PLAY/PAUSE button again to resume play.  
SKIP DURING PLAY MODE  
1. Press SKIP button once to skip to the beginning of the next track;  
2. Press SKIP button once to skip to the beginning of the correct  
track;  
REMOTE CONTROL OPERATION  
3. Press SKIP twice quickly in succession to go back to previous  
Open the Battery Compartment Door and insert two pieces "AAA" size batteries into  
the battery compartment with battery polarity as shown inside the battery  
compartment.  
Point the remote control at the remote sensor. The functions of the buttons on the  
remote control are same as the corresponding controls on the main unit.  
tracks.  
SEARCH DURING PLAY MODE  
1. Press and hold the search buttons to quickly advance or reverse  
through the music at high speed;  
2. Release the SEARCHbutton to return to normal play mode.  
- 5 -  
- 6 -  
 
1.  
2.  
3.  
4.  
5.  
6.  
Stop Button  
USEFULADVICE BEFORE REQUIRING SERVICE SUPPORT  
Many of the problems are probably caused by improper adjustments of the product or by  
simple problems. Before contacting your Service Centre for help, check the following table.  
Skip/SearchButton  
Skip/SearchButton  
Repeat Button  
Play/Pause Button  
Battery Compartment  
PROBLEM  
CAUSE AND REMEDY  
GENERAL  
No Power Supply  
- Check that the power cord is properly  
connected to wall out.  
No Audio  
- Adjust the volume.  
Warning:  
- You have not connected the speaker boxes;  
plug the main unit speaker terminals.  
- Your Hi-Fi system is too close to a TV set  
or a VCR; move away from the TV set or  
the VCR.  
When the remote will not be used for a long time, remove the batteries in order  
to prevent damage due to electrolyte leakage.  
Evident Audio Disturbances  
HANDLING A DISC  
RADIO RECEPTION  
Always protect a disc against scratches, soil and dust etc. We recommend that  
the discs should be stored in the original case during non-use periods.  
Bear in mind the following points, since any dirt, scratches or  
warping of the disc can cause broken or intermittent sound  
and also noise.  
The FM Stereo Indicator Blinks.  
- Rotate the set and extend the FM Antenna.  
Evident Audio Disturbance.  
- Rotate the set and extend the FM Antenna.  
CD OPERATION  
z When holding the discs, take care not to touch the playing  
surface.  
The CD Compartment does not  
close  
- The disc is not placed correctly in its  
compartment.  
z Store the discs in their cases. Return them to their cases  
with the label surface facing up and push down lightly on  
the label surface.  
z Do not place discs near a heating device or a place where  
the temperature is high or in dusty areas.  
z Do not write on the label surface using a ballpoint pen and  
do not stick labels on the CD.  
z Wipe away any fingerprints or dust on the playing surface  
of a disc using a soft cloth.  
The Playback does not start  
- The CD is dirty.  
- The CD was placed wrongly.  
- The pause mode was activated.  
- Inside the CD player some moisture  
condensation occurred; leave the unit in a  
warm room for one or two hours.  
- The CD surface is dirty or scratched.  
No Audio During Playback  
If after checking this table the unit fails to operate normally. Consult the nearest Authorized  
Service centre.  
Bear in mind the following points:  
- Always wipe from the inside toward the outside of the disc.  
- Never in a circular motion.  
- Do not use conventional record cleaners, anti-static agents,  
benzene, thinner or other solvents.  
- 8 -  
- 7 -  
 
CARE AND MAINTENANCE  
Precautions  
1. Always turn OFF the unit after use;  
2. Keep the unit away from magnetic objects, water or any heat sources;  
3. Use a clean soft moist cloth to clean the unit’s cabinet. Do not use  
chemical cleaners that could damage the finishing of the unit;  
4. Never touch the CD pickup lens. If fingerprints get on the pickup lens,  
use a commercial lens cleaner.  
5. Disconnect the unit from any power sources before starting the  
cleaning operation.  
SPECIFICATION  
CD SECTION  
Channels:  
2 channels  
Pick up light source:  
semiconductor laser  
RADIO SECTION  
Frequency range:  
AM 520 - 1710 KHz  
FM 87.5 - 108 MHz  
FM antenna wire  
Antenna:  
GENERAL  
Power output  
Power consumption  
Power source  
2W + 2W  
15W  
AC 120V ~ 60Hz  
Specifications are subject to change without further notice.  
FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE, PLEASE VISIT  
OUR WEBSITE AT WWW.MEMOREXELECTRONICS.COM OR CONTACT  
CUSTOMER SERVICE AT (954) 660-7100  
PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN  
CASE YOU NEED TO RETURN THIS PRODUCT TO YOUR PLACE OF  
PURCHASE OR MEMOREX.  
FOR PARTS AND ACCESSORIES, CONTACT FOX INTERNATIONAL AT  
1-800-321-6993  
- 9 -  
 

Kuppersbusch USA Food Warmer GMS 65400 E UL User Manual
KWC Indoor Furnishings S10C302 User Manual
Lenovo Laptop 2958XFU User Manual
LG Electronics Cell Phone VI5225 User Manual
Logitech Mouse G400 User Manual
Louisville Tin and Stove Furnace HEDV403 User Manual
Magnavox CD Player FW 754P User Manual
Makita Router 3620A User Manual
Metra Electronics Car Stereo System 99 3410 User Manual
Microsoft Window CA24T A3 User Manual