Nokia Bluetooth Headset BH 109 User Manual

Nokia Bluetooth Headset BH-109  
Issue 1.0  
 
3
This device is compliant with Bluetooth Specification 2.1 + EDR supporting the following  
profiles: Headset Profile 1.1 and Hands-Free Profile 1.5. Check with the manufacturers  
of other devices to determine their compatibility with this device.  
Get started  
Keys and parts  
1
2
3
4
5
6
7
8
Power key  
Earloop  
Microphone  
Call key  
Earpiece  
Indicator light  
Volume key  
Charger connector  
 
4
Charge the battery  
Before using the headset, you must charge the battery.  
Warning:  
Use only chargers approved by Nokia for use with this particular model. The use of any  
other types may invalidate any approval or warranty, and may be dangerous. Use of  
unapproved chargers may present a risk of fire, explosion, or other hazard.  
When you unplug a charger, hold and pull the plug, not the cord.  
1
2
Connect the charger to a wall outlet.  
Connect the charger cable to the charger connector in the headset. The red indicator  
light turns green when the battery is fully charged.  
3
Disconnect the charger from the headset, then from the wall outlet.  
The fully charged battery has power for up to 8 hours of talk time and up to 200  
hours of standby time.  
When the battery charge is low, the headset beeps every 5 minutes and the red indicator  
light flashes.  
Check the battery charge  
With the headset connected to the mobile device, press the power key. Green light  
indicates sufficient charge level. If the light is yellow, you may need to recharge the  
battery soon. If the light is red, recharge the battery.  
Switch the headset on or off  
Press and hold the power key for 2 seconds.  
When switched on, the headset beeps, and a green indicator light flashes once. The  
headset tries to connect to a paired mobile device.  
If the headset is not connected to a device within 30 minutes, it switches off.  
When switched off, the headset beeps, and a red indicator light flashes once.  
Pair and connect the headset  
With pairing, you can control which devices are allowed to connect to your headset.  
Before using the headset, you must pair and connect it to a compatible device.  
1
Switch the headset off and the compatible device on.  
 
5
2
3
If you have never paired the headset with a device, or you have emptied the paired  
devices list, switch the headset on. If you have previously paired your headset with  
another device, press and hold the power key for 5 seconds. The headset enters  
pairing mode, and the green indicator light starts to flash quickly.  
Within 3 minutes, activate Bluetooth on thedevice, and set it to search for Bluetooth  
devices. For details, see the user guide of the device.  
4
5
Select the headset from the list of found devices.  
If required, enter the passcode 0000.  
You can pair your headset with 8 compatible devices, but you can only connect it to a  
maximum of 2 devices at the same time.  
With some mobile devices, you may need to make the connection separately after  
pairing.  
Connect the headset to the last used device manually  
Press and hold the call key for 2 seconds, if no other device is connected, or go to the  
Bluetooth menu of the device.  
Wear the headset  
Slide the earloop behind your ear (9), and gently push the earpiece against your ear.  
Carefully bend the earloop around your ear for the best fit. Push or pull the earloop to  
set its length. Point the headset towards your mouth (10).  
The headset is ready to be used on the right ear. To use the headset on the left ear,  
rotate the earloop so that it is to the left of the Nokia logo (11 and 12).  
 
6
Make calls  
Make and receive calls  
Make a call  
When the headset is connected to your compatible mobile device, make a call normally  
using your mobile device.  
Answer or end a call  
Press the call key.  
Reject a call  
Press the call key twice.  
Switch a call between your headset and mobile device  
During a call, press the call key for 2 seconds.  
You can redial the number you last called or make a call by using your voice, if your  
mobile device supports these features with the headset.  
Redial the last called number  
When no call is in progress, press the call key twice.  
Activate voice dialling  
When no call is in progress, press and hold the call key for 2 seconds, and follow the  
user guide of your mobile device.  
Change the volume  
Use the volume key. To change the volume quickly, press and hold the volume key.  
Switch between calls  
If you get two calls at the same time, you can handle both calls hands-free.  
If your mobile device uses the call waiting function (network service), and supports the  
Bluetooth Hands-Free Profile 1.5, you can switch between two calls using the headset.  
Put the call on hold, and answer a waiting call  
Press and hold the call key for 2 seconds.  
Switch between the calls  
Press and hold the call key for 2 seconds.  
 
7
End the call and answer the other one  
Press the call key.  
Pair and connect the headset to two devices  
You can connect your headset to two devices, for example, when you want to make calls  
using both your personal and your work mobile device.  
Switch on the headset, activate pairing mode, and pair the headset with the first device.  
Switch off the headset, activate pairing mode, and pair it with the second device. To  
connect the headset to the two devices, switch the headset off and back on.  
Switch back to one device only  
1
2
Switch off the headset.  
Press and hold the power key for 5 seconds. The green indicator light starts to flash  
quickly.  
3
Press and hold the power key and the volume down key for 5 seconds. The yellow  
indicator light flashes once.  
Switch to two devices again  
1
2
Switch off the headset.  
Press and hold the power key for 5 seconds. The green indicator light starts to flash  
quickly.  
3
Press and hold the power key and volume up key for 5 seconds. The green indicator  
light flashes once.  
Handle calls from two devices  
If your headset is connected to two mobile devices, you can handle calls from both at  
once.  
End the call, and answer a call on the other device  
Press the call key.  
Put the call on hold, and answer a call on the other device  
Press and hold the call key for 2 seconds.  
Switch between the calls  
Press and hold the call key for 2 seconds.  
End the ongoing call, and activate the hold call  
Press the call key.  
 
8
If you want to redial or use voice dialling, the call is made on the device you last used  
with the headset.  
Settings  
Switch the lights off  
You can switch the indicator lights off if you do not want them to be shown, for example,  
during a call.  
When the headset is connected to a device, press and hold the call key and the volume  
down key for 5 seconds. The yellow indicator light flashes once. Some indication lights  
may still be shown, for example, when the battery charge is low.  
Switch the lights back on  
Press and hold the call key and the volume up key for 5 seconds. The green indicator  
light flashes once.  
Clear the pairing  
You can manually empty the paired devices list from your headset.  
Switch the headset off, and press and hold the power key and the call key for 9 seconds.  
The red and green indicator lights alternate. You can pair the headset with a device, if  
desired.  
Troubleshooting  
Cannot connect the headset to a compatible device? Make sure the headset is  
charged, switched on, and paired with the device.  
Did the headset stop functioning even though it is charged? Plug the charger into  
a wall outlet, and while you press and hold the power key, connect the headset to  
the charger.  
Product and safety information  
Battery and charger information  
This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you  
may damage the device. Take the device to the nearest authorised service facility for replacement of the battery.  
This device is intended for use when supplied with power from the following chargers: AC-3, AC-4, AC-5, AC-8, DC-4, and DC-9.  
The exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following:  
E, X, AR, U, A, C, K, or B.  
The battery can be charged and discharged hundreds of times, but it will eventually wear out. When the operating times are  
noticeably shorter than normal, take the device to the nearest authorised service facility for battery replacement.  
Recharge your battery only with Nokia approved chargers designated for this device.  
 
9
If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to  
connect the charger, then disconnect and reconnect it to begin charging the battery. If the battery is completely discharged, it  
may take several minutes before the charging indicator light is displayed.  
When your charger is not in use, unplug it from the electrical plug and the device. Do not leave a fully charged battery connected  
to a charger, as overcharging may shorten the battery’s lifetime. If left unused, a fully charged battery will lose its charge over  
time.  
Always keep the battery between 15°C and 25°C (59°F and 77°F). Extreme temperatures reduce the capacity and lifetime of the  
battery. A device with a hot or cold battery may not work temporarily.  
Do not dispose of batteries in a fire as they may explode. Dispose of batteries according to local regulations. Recycle when  
possible. Do not dispose as household waste.  
Never use any charger that is damaged.  
Operating times are estimates only. Actual performance depends on many factors such as device settings selected, device  
features being used (or running in the background), battery condition and ambient temperature.  
Take care of your device  
Handle your device, battery, charger and accessories with care. The following suggestions help you protect your warranty  
coverage.  
Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode  
electronic circuits.  
Do not use or store the device in dusty or dirty areas. Moving parts and electronic components can be damaged.  
Do not store the device in high temperatures. High temperatures can shorten the life of the device, damage the battery,  
and warp or melt plastics.  
Do not store the device in cold temperatures. When the device warms to its normal temperature, moisture can form inside  
the device and damage electronic circuits.  
Do not attempt to open the device.  
Unauthorised modifications may damage the device and violate regulations governing radio devices.  
Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and mechanics.  
Only use a soft, clean, dry cloth to clean the surface of the device.  
Do not paint the device. Paint can clog the moving parts and prevent proper operation.  
Recycle  
Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way you  
help prevent uncontrolled waste disposal and promote the recycling of materials. Check product environmental information  
and how to recycle your Nokia products at www.nokia.com/werecycle, or with a mobile device, nokia.mobi/werecycle.  
Crossed-out wheeled-bin symbol  
The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and  
electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This  
requirement applies in the European Union. Do not disposeofthese products asunsortedmunicipal waste. Formore information  
on the environmental attributes of your device, see www.nokia.com/ecodeclaration.  
 
10  
Copyright and other notices  
DECLARATION OF CONFORMITY  
Hereby, NOKIA CORPORATION declares that this BH-109 product is in compliance with the essential requirements and other  
relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/  
© 2010 Nokia. All rights reserved.  
Nokia, Nokia Connecting People, and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia  
Corporation. Nokia tune is a sound mark of Nokia Corporation. Other product and company names mentioned herein may be  
trademarks or tradenames of their respective owners.  
Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior  
written permission of Nokia is prohibited. Nokia operates a policy of continuous development. Nokia reserves the right to make  
changes and improvements to any of the products described in this document without prior notice.  
Bluetooth is a registered trademark of Bluetooth SIG, Inc.  
The contents of this document are provided "as is". Except as required by applicable law, no warranties of any kind, either  
express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose,  
are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document  
or withdraw it at any time without prior notice.  
To the maximum extent permitted by applicable law, under no circumstances shall Nokia or any of its licensors be responsible  
for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.  
The availability of particular products may vary by region. Please check with your Nokia dealer for details. This device may  
contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion  
contrary to law is prohibited.  
/Issue 1.0 EN  
 

Munchkin High Chair Portable Hook On Chair User Manual
NEC Flat Panel Television S401AVT User Manual
Nikon Frozen Dessert Maker 1423000 User Manual
Nokia Satellite TV System 9600C User Manual
Novatel Wireless Network Router CC208 User Manual
NuTone Telephone VSA4S User Manual
NXR Range DRG83602 User Manual
Omnimount TV Mount 1N1 S User Manual
Oster Toaster TSSTTRDFL2 User Manual
Parkside Sander PHS 160 A1 User Manual