Bosch Appliances Security Camera VJR A3 IC User Manual

AutoDome Junior  
VJR-A3-IC  
en Installation Manual  
 
AutoDome Junior  
Table of Contents | en  
3
Table of Contents  
1
Installing a Recessed Mount  
4
4
4
5
8
1.1  
Description  
1.1.1  
1.1.2  
1.1.3  
Additional Requirements  
Preparing the Ceiling for Installation  
Installing the Camera to the Mounting Plate  
Bosch Security Systems, Inc.  
Installation Manual  
F.01U.168.034 | 3.0 | 2010.12  
 
4
en | Installing a Recessed Mount  
AutoDome Junior  
1
Installing a Recessed Mount  
1.1  
Description  
This chapter details how to recess mount the AutoDome Junior.  
NOTICE!  
The image sensors in modern CCD cameras are highly sensitive  
and require special care for proper performance and extended  
lifetime. Follow the guidelines for optimum results with your  
camera:  
Do not expose to direct sunlight or bright spotlights in  
operating and nonoperating conditions.  
Avoid bright lights in the field of view of the camera. Bright  
lights cause a “smearing” effect, which is visible as white  
lines above and below the highlight. Prolonged exposure to  
bright lights may cause bleaching of the sensor's color  
filters. This will be visible as colored spots in the picture  
and is irreversible.  
1.1.1  
Additional Requirements  
Appropriate straight slot screwdrivers  
No. 2 Phillips screwdriver  
Appropriate tool for cutting a hole in drywall or ceiling tile  
(if applicable)  
4 in. x 4 in. junction box (optional)  
T-10 Torx wrench  
VJR-A3-SP, support kit for VJR-A3-IC mounting kit  
F.01U.168.034 | 3.0 | 2010.12  
Installation Manual  
Bosch Security Systems, Inc.  
 
AutoDome Junior  
Installing a Recessed Mount | en  
5
1.1.2  
Preparing the Ceiling for Installation  
To mount to a recess mount, do the following:  
1. Determine a secure location for the recessed mount  
(supplied separately).  
104.9  
(4.13)  
71.6  
(2.82)  
mm  
(in.)  
229.0  
(9.02)  
Figure 1.1 Recess Mount Dimensions  
2. Drill or cut a 200 mm hole with a tolerance of 2.2 mm ( 7.9  
in. 1/8).  
3. Optional: if installing the AutoDome Junior HD to a  
suspended ceiling tile or any other surface where  
additional support is required, the VJR-A3-SP mounting kit  
is recommended (supplied separately).  
Bosch Security Systems, Inc.  
Installation Manual  
F.01U.168.034 | 3.0 | 2010.12  
 
6
en | Installing a Recessed Mount  
AutoDome Junior  
4. Align holes of mounting plate (supplied with dome) with  
mounting bracket and attach with screws. Ensure that  
both the crescent shape of the mounting plate and the  
crescent shape of the mounting bracket are aligned.  
Figure 1.2 Attach Mounting Plate to Mounting Bracket  
1
2
3
4
5
Mounting Bracket  
Mounting Plate  
Clamping Plate  
Crescent Shape  
Clamp Drive Screw  
5. Loosen the two clamp drive screws (item 5, above) so that  
the clamping plates move freely.  
6. Insert mount through the hole in the ceiling. Slide clamps  
out and down so that the ceiling/drywall is captured in  
between the clamps and the bracket flange. The ceiling/  
drywall must have a maximum thickness of 41.7 mm  
(1.64 in.) and an minimum thickness of 12.7 mm (0.50 in.).  
F.01U.168.034 | 3.0 | 2010.12  
Installation Manual  
Bosch Security Systems, Inc.  
 
AutoDome Junior  
Installing a Recessed Mount | en  
7
Figure 1.3 Attach Recess Mount to Ceiling  
7. Tighten both clamps using the clamp drive screws  
(installed on the assembly) and a #2 Phillips screwdriver.  
NOTICE!  
Over-torquing the ceiling clamps can damage the clamp or  
ceiling. Only tighten the clamp until it contacts the ceiling and  
you start to feel some resistance. If using a power screwdriver,  
set the torque level to the lowest setting.  
NOTICE!  
If you need to install the the VJR-A3-SP Support Bracket, refer  
to the guide included with the bracket. Once the bracket is  
installed, continue with the next section.  
Bosch Security Systems, Inc.  
Installation Manual  
F.01U.168.034 | 3.0 | 2010.12  
 
8
en | Installing a Recessed Mount  
AutoDome Junior  
1.1.3  
Installing the Camera to the Mounting Plate  
To install the base to a surface or suspended ceiling using the  
supplied mounting plate, do the following:  
1. Loosen the single safety locking screw on the base of the  
unit using the user-supplied T-10 Torx wrench.  
Figure 1.4 Unlock Safety Locking Screw  
CAUTION!  
All wires for installation applications must be routed through a  
grounded conduit.  
2. Remove the screw from the Earth ground ( )on the top  
of the mounting bracket.  
3. Attach a user-supplied ground wire to the Earth ground  
(
) screw hole on the mounting bracket and secure with  
the screw.  
4. Attach the green grounding wire from the unit to the  
grounded ( ) screw hole on the mounting bracket using  
the attached captive screw washer.  
5. Route wires on the side of mounting plate with the  
crescent shaped cut-out.  
6. Connect the mating connectors (supplied in the accessory  
kit) with the flying leads to the user supplied wiring.  
F.01U.168.034 | 3.0 | 2010.12  
Installation Manual  
Bosch Security Systems, Inc.  
 
AutoDome Junior  
Installing a Recessed Mount | en  
9
7. Plug the matching connectors from the camera into the  
mating connectors from the ceiling.  
Figure 1.5 Match Connectors  
1
2
3
4
Locking Screw  
Crescent Shape  
Mounting Plate  
Vertical Tab  
Bosch Security Systems, Inc.  
Installation Manual  
F.01U.168.034 | 3.0 | 2010.12  
 
10 en | Installing a Recessed Mount  
AutoDome Junior  
8. Attach the camera to the mounting plate by inserting the  
vertical tab on the plate (item 1, below) into the recessed  
slot on the top of the camera dome (Item 3) to the right of  
the safety locking screw (item 2).  
Note: Do not loosen the three brass buttons (item 4).  
These brass buttons engage the slotted tabs (item 5) on  
the mounting plate.  
Figure 1.6 Tab/Slot Alignment Detail  
1
2
3
4
5
Vertical Tab (on mounting plate)  
Locking Screw  
Recessed Slot (on dome housing)  
Brass Button (total of three on housing)  
Slotted Tab (total of three on mounting plate)  
F.01U.168.034 | 3.0 | 2010.12  
Installation Manual  
Bosch Security Systems, Inc.  
 
AutoDome Junior  
Installing a Recessed Mount | en 11  
9. Rotate the camera approximately 15 degrees in the  
clockwise direction. Then, lock firmly into place, as shown  
in the next illustration.  
Figure 1.7 Attach Dome to Mounting Plate  
1
2
3
Recess Mounting Bracket  
Mounting Plate  
Mounting Bracket Tether Point  
10. Ensure unit is centered.  
NOTICE!  
The recessed mounting bracket is provided with an additional  
safety tether point. To prevent injury, attach a safety wire from  
a secure anchor point above the ceiling to this tether point.  
Bosch Security Systems, Inc.  
Installation Manual  
F.01U.168.034 | 3.0 | 2010.12  
 
12 en | Installing a Recessed Mount  
AutoDome Junior  
11. Align trim ring so the four alignment posts (item 1, below)  
align with the recesses in the camera housing (item 2) and  
so the two safety screws align with the off center holes  
(item 3) on the locking clamps.  
Note: The two (2) sets of raised stand-off tabs (item 4) on  
each side of the trim ring align with the locking clamps.  
Figure 1.8 Align Trim Ring  
1
2
3
4
Alignment Tabs (four)  
Align tabs to the recessed areas on the housing  
Align safety locking screws to these connections  
Stand-off Tabs (two)  
12. Snap trim ring into place. Ensure snaps are secure by  
attempting to lightly turn unit. Note: Unit should not turn.  
13. Use the supplied T-10 Torx wrench to secure the trim  
ring’s two (2) safety locking screws to the mounting  
bracket.  
F.01U.168.034 | 3.0 | 2010.12  
Installation Manual  
Bosch Security Systems, Inc.  
 
 
Bosch Security Systems, Inc.  
850 Greenfield Road  
Lancaster, PA 17601  
U.S.A.  
© Bosch Security Systems, Inc., 2011  
 

Belkin Surge Protector PM01629 User Manual
Bosch Power Tools Power Hammer 11318EVS User Manual
Briggs Stratton Automobile Parts 124335 8104 01 User Manual
Cambridge Audio Stereo Amplifier Azur 840E User Manual
Canon All in One Printer 2237B007AA User Manual
Canon Games BJ BJ139 User Manual
Casio PDAs Smartphones IT 500 User Manual
Cerwin Vega Speaker System CLS 12 User Manual
Chauvet Oven D Fi 24 Rx User Manual
Cisco Systems Network Card PA 4C E 1 User Manual