Carcomm PDAs Smartphones CMPC 22 User Manual

Mobile PDA CCradle  
CMPC-22 Fujitsu-Siemens PocketLoox 410  
Introduction  
This installation manual has been prepared to provide the basic information needed to  
install the CMPC-22. This manual is not intended to be definitive, because there are  
different models and types of vehicles which will require different installation work.  
The information given is for general guidance only.  
The terms of warranty demand that this mobile PDA cradle is installed by an experienced  
installer. An end-user should never attempt to install this mobile PDA cradle without  
professional assistance as the installation requires special tools and knowledge.  
Note: Thoroughly read the manual before beginning the installation procedure.  
WARNINGS  
1. Ensure that the vehicle’s battery is disconnected before you start the installation  
procedure and that it remains disconnected during the procedure.  
2. Do not smoke or use open flames when working near the vehicle’s fuel system.  
Compatible devices  
3. Ensure that the vehicle’s electrical cables, hydraulic lines, fuel lines and safety  
equipment are not damaged during the installation.  
Fujitsu-Siemens PocketLoox 410  
Fujitsu-Siemens PocketLoox 420  
Fujitsu-Siemens PocketLoox N500  
Fujitsu-Siemens PocketLoox N520  
Fujitsu-Siemens PocketLoox C550  
4. Ensure that normal control and operation of the vehicle is not obstructed by the  
installation,particularly the brakes and steering. Ensure that airbag operation is not  
obstructed.  
5. Electronic and other sophisticated systems (for example speed control, ABS anti-lock  
brake,fuel injection-, navigation- and airbag systems) are relatively immune to  
malfunction caused by PDA or GPS receiver. However, should you experience false  
operation of these systems or are in any doubt whatsoever as to their functionality,  
please consult the vehicle’s dealer.  
6. The mobile PDA cradle is suitable for use only in vehicles with a 12V negative  
grounding. Use on other supply voltages or alternative polarity will damage the  
equipment.  
7. The PDA should not be left switched on for extended periods without running the  
vehicle’s engine. Failure to comply could drain the vehicle’s battery.  
Before starting the installation of the mobile PDA cradle please check if the following  
contents are present :  
- Mobile PDA Cradle  
- Rotating Swivel  
- Window Mount  
- Suction Cup  
- Fuse Holder cable with fuse  
- Screw sets  
- Surface cleaner  
- Manual  
Safety-Mount® pattern  
© Copyright Carcomm International BV 2006. Subject to change without previous notice.  
All used brandnames are owned by their respective owners  
1
 

Black Decker Iron F1000 User Manual
Black Widow Security Automobile Alarm BW 1500 User Manual
Blodgett Convection Oven BC14E User Manual
Bosch Appliances Security Camera PT 400 User Manual
Briggs Stratton Air Cleaner 110400 User Manual
Briggs Stratton Switch 071019 User Manual
Cabletron Systems Switch BRIM A6 User Manual
Carcomm Cell Phone Accessories CMPC 15 HTC Himalaya Alpine Qtek 2020 2020i User Manual
Casio Musical Instrument LK210 215ES1A User Manual
Celestron Telescope C100ED R User Manual